95sporty150
Member
This is gonna be a slow process, but I've started collecting the parts. Hope to have it up and running by Christmas.
The plans are 393 CHP stroker. 9:1 cr
Afr 185 heads
Crane 2030 powermax
Edelbrock truck performer intake
The heads are at a shop now getting new springs after I developed compression issues.
So far I have the following:
BW S475
BBK headers
Cold and hot side raw tubing
Summit intercooler
Dynomax 4" bullet muffler
Precision Industries 46mm gate
Turbosmart race port bov
Psd bumper and all trim
All the vbands
What I still need:
Fuel system ( I'd say ten years of sitting in a garage with gas, all of my old components are shot), front to back
Tuning or aftermarket engine management ( looking hard at the Holley system)
Odds and ends
Oil filter relocation kit
Head stud kit
Probably a new gearset, from what I've seen 4:10s may be to much for a turbo setup
The plans are 393 CHP stroker. 9:1 cr
Afr 185 heads
Crane 2030 powermax
Edelbrock truck performer intake
The heads are at a shop now getting new springs after I developed compression issues.
So far I have the following:
BW S475
BBK headers
Cold and hot side raw tubing
Summit intercooler
Dynomax 4" bullet muffler
Precision Industries 46mm gate
Turbosmart race port bov
Psd bumper and all trim
All the vbands
What I still need:
Fuel system ( I'd say ten years of sitting in a garage with gas, all of my old components are shot), front to back
Tuning or aftermarket engine management ( looking hard at the Holley system)
Odds and ends
Oil filter relocation kit
Head stud kit
Probably a new gearset, from what I've seen 4:10s may be to much for a turbo setup