MorpheusGPR
Active member
Is this PSI where Matt works? If so I hear you are the person to see about some engine parts for a Chevy
I have the heads off a chevy 350 (corvette motor) 1970 LT-1 block.
What specs will you need to get me correct parts for the heads?
I had some springs fall apart so I will need at min. springs, and I think valves. I would like to get good quality parts, titanium? I am considering getting the heads ported while they are off but only if the cost is low.
Let me know and I will try to get some more specs, it was built for my Dad years ago.
A couple of the rockers appeared to have some rubbing on the sides from after the springs fell apart. I am hoping they are ok though.
Thanks.
I have the heads off a chevy 350 (corvette motor) 1970 LT-1 block.
What specs will you need to get me correct parts for the heads?
I had some springs fall apart so I will need at min. springs, and I think valves. I would like to get good quality parts, titanium? I am considering getting the heads ported while they are off but only if the cost is low.
Let me know and I will try to get some more specs, it was built for my Dad years ago.
A couple of the rockers appeared to have some rubbing on the sides from after the springs fell apart. I am hoping they are ok though.
Thanks.