Finishing the truck, goodies coming in.

[FlatOut]

Getting back to working on the truck. Would putting a intake spacer be a good idea? I am running a performer rpm with a holley sniper setup, carb style efi. Would it help with heat transfer from the intake?

I don't think you get much benefit from the thermal transfer but I've heard that they do help with the drivability with a sniper type EFI system because they add a little "plenum" volume and allow some cross over on a dual plane intake. I've milled the bridge out of a couple intakes for guys running similar style EFI for this reason.

 

[94whtlite#2669]

Got a new toy a few weeks ago to occupy my time while I finish the the truck. 2013 grabber blue gt. It got new sneakers this weekend

 

[RPM289]

That is SWEET!


Sent from my iPhone using Tapatalk

 

[94whtlite#2669]

Started working on the truck again, got the new trans crossmember in and seats out of a newer focus. I did not have any decent L seats. Waiting on a few exhaust pieces to show up so I can start on that this weekend

 

[RPM289]

Started working on the truck again, got the new trans crossmember in and seats out of a newer focus. I did not have any decent L seats. Waiting on a few exhaust pieces to show up so I can start on that this weekend Looking great!

 

[FMOS Racing]

I'd love to drive over one weekend since we're basically neighbors.

 

[94whtlite#2669]

I'd love to drive over one weekend since we're basically neighbors.

Any weekend is good. Main goal now is to finish the truck for next spring.

 

[94whtlite#2669]

Since I put in a new trans crossmember I had to redo the exhaust. Stupid move was building the first exhaust before putting the crossmember in. Next is to put a 255 pump in the tank, fuel line extension from the factory line to my holley sniper and the frame harness to go to the back of the truck.