LIGHTNINROD
Active member
Hey guys, I went to South Georgia Corvettes in Thomasville for my second dyno today. The first one was back in July--many changes in my L since then.
I used my PSP chip on the first pull---It gave me 396.3 RWHP and 488.5 RWTQ. A few minutes later I installed my JL chip and it gave me 400.2 RWHP and 472.3 RWTQ. Both showed they were very rich(therefore, safe)--A/F ratios in the low 11s.
Aaron Scott had 12 Corvettes in his shop. One of them was from Tennessee. It was a Lingenfelter--600+ RWHP. It had been in an issue of C&D when they tested several high-end cars(Ruff Porsche, Viper, etc.) and it had the quickest time--23.xxx seconds--from 0 to 150 and back to 0! Aaron must be good to get this car in for work in his shop! It had a TPS with a broken wire that his dealer couldn't find and some vacuum leaks.
Dan
I used my PSP chip on the first pull---It gave me 396.3 RWHP and 488.5 RWTQ. A few minutes later I installed my JL chip and it gave me 400.2 RWHP and 472.3 RWTQ. Both showed they were very rich(therefore, safe)--A/F ratios in the low 11s.
Aaron Scott had 12 Corvettes in his shop. One of them was from Tennessee. It was a Lingenfelter--600+ RWHP. It had been in an issue of C&D when they tested several high-end cars(Ruff Porsche, Viper, etc.) and it had the quickest time--23.xxx seconds--from 0 to 150 and back to 0! Aaron must be good to get this car in for work in his shop! It had a TPS with a broken wire that his dealer couldn't find and some vacuum leaks.
Dan
