Calling GEN1_4_U_2_NV

[Black Stallion]

My level 10 came in yesterday:tu: How many pieces are in the kit? I have 7 pieces total. 3 large springs, 3/8" valve and valve housing, and 1/2" valve and valve housing.
Did you use the 3/8" or the 1/2". I plan on using the 1/2" since this truck is not my daily driver.

Thanks

 

[Black Stallion]

gaskets?

which ones? Ford said there are like 5 different types. I told him "94 Lightning specific E4OD, the same as a 4X4 F-150 with the same tranny" he said get a number off of the tranny.
Well one small problem. My L is in my buddies garage getting a stereo installed.
Can I get these gaskets at pep boys, or auto zone, schucks....etc.

thanks man:tu:

I don't know where I would be with out the NLOC

 

[sstock]

Black, no sure which one for you to use, I put mine in a couple years ago and there was only 1 piston and valve. Give level ten a call, or ask on the GEN 1 board
Later
STeve

 

[fairlane]

The bigger valve is the street strip valve.Tell them you need the cork gasket for a E40D.You can also get a trans pan from a 99 -2002 superduty 4x4.It holds more fluid and has a drain plug and it uses a reusable rubber seal that doesnt come with the pan and make sure to get the filter to go with the deeper pan if you decide to get it.

 

[GEN1_4_U_2_NV]

Yes you can get the gasket at PEP boys. I used the half inch valve on mine, and suggest that be the one that you use. If you go with that 4x4 pan, then get the gasket for that same pan. If not then get the gasket for the stock pan. Dont forget to change the tranny filter while you are in there!

 

[Black Stallion]

Thanks guys,

I am putting the kit in this sat. I have read the directions at least a dozen times and with your guys input and help install should be a breeze.

Can't wait to bark 'em on the 1-2

Thanks again guys:w