Alignment specs

[DBlightning]

I know someone had posted these before, Im having the front alignment done when I get new tires and Im not sure if I need the specs or not. I know it is different from a regular f150. Thanks in advance.

 

[Copperhead]

CAMBER - 0 deg Right , 0 deg Left
CASTER - 5.9 deg Right , 5.6 deg Left
TOE - 1/32" Right , 1/32" Left

 

[Litl Sam]

What about this

I got this from somewhere?

Camber spec is 0.0* on both side with tolerance of + or - 0.5* on each side

Caster spec is 4.1 * on the left and 4.5* on the right with tolerance of + or - 0.4* on each side

Toe spec is 0.02” on both sides with tolerance of + or - 0.06” on each side

Cross camber and cross caster is + or - 0.5*

Total toe spec is 0.03” with tolerance of + or - 0.13”

Thrust angle on the rear end should be 0.00*


Which is right?

 

[DBlightning]

db

Ok so which is it Im having the front alignment done on the 9th and I need to know. Thank for your help.

 

[DBlightning]

Can anyone shed some light on the subject. Any help would be helpful. Thanks again.

 

[George G.]

So which one is the right one? Anybody? Are both of y'all sure those aren't the specs for a lowered truck? I'm needing my centerlink and camber bushings replaced and then an alignment also. I would like to verify with the shop that they're using the right specs.

George

 

[core-rider]

I don't know if those alignment specs are correct according to Ford, but they are real close to what my truck is set up to. I have had no abnormal tire wearing issues at all. My truck has been lowered 1.5 f/2 r.

My specs are:
-1.4 left -1.6 right camber with a cross camber of 0.2

5.3 left 6.2 right caster with -0.9 cross caster

0.04 left 0.05 right toe with 0.09 total toe

I'm soon going to lower my truck to 3/4 and hope to keep a similar setup. Hope this info helps you guys out at all.